IP Cam Viewer     My Amazon IP Cameras     Cheap Wifi Pan/Tilt/Audio Camera with Good Night Vision    

IP Cam Viewer Parameters

Support for my free Android Applications.

IP Cam Viewer Parameters

Postby nogueira13 » Tue Jun 21, 2011 6:45 am

I have my IP cam working properly and I can access it outside of my home. But the only thing I am not being able to do is to change the brightness of the image provided by the IP Cam with the app IP Cam Viewer, I would like to know also what does mean the buttons B+ B- C+ C- and so on. The minus and adding symbols I already find out what they do: It is zooming features. Others buttons I don't know also what they do are the buttons labelled with 1 2 3 4 5 etc. Where I could find a manual of the GUI commands of the IP Cam Viewer?
Thanks a lot in advance for any help.
nogueira13
 
Posts: 1
Joined: Mon Jun 13, 2011 12:13 pm

Re: IP Cam Viewer Parameters

Postby N4Spd » Thu Jun 30, 2011 12:12 pm

descriptions of the ptz command panel is available at:

http://hit-mob.com/ip-cam-viewer-android/help/

each camera type can also have custom buttons that vary from camera to camera.
B- B+ is usually brightness adjustment
C- C+ is usually contrast adjustment
Ph Pan horizontal
Pv Pan vertical
Pa Patrol
St Stop

In the future, these buttons will be converted to images.

thx rob
N4Spd
 
Posts: 1284
Joined: Sun Feb 08, 2009 3:25 pm

Re: IP Cam Viewer Parameters

Postby gsronald » Sat Jul 02, 2011 7:00 am

How about M+ and Mo on EasyN 613?

After I updated the IP Cam View, it pan always from end to another end and seems out of control but i using the native EasyN web portal to control, it behave as normal and usual.

Please help!?
gsronald
 
Posts: 1
Joined: Sat Jul 02, 2011 6:56 am

Re: IP Cam Viewer Parameters

Postby N4Spd » Wed Jul 20, 2011 12:15 pm

slow down the default pan tilt speed in the camera settings.

touch down starts pan, touch up stops pan. if camera is too fast or network is too slow then you get lots of pan.

as for M+, it switches between 50hz/60hz/outdoor. Mo is outdoor.

next release will replace these text buttons with icons, and it'll toast what it does when you press it.

gsronald wrote:How about M+ and Mo on EasyN 613?

After I updated the IP Cam View, it pan always from end to another end and seems out of control but i using the native EasyN web portal to control, it behave as normal and usual.

Please help!?
N4Spd
 
Posts: 1284
Joined: Sun Feb 08, 2009 3:25 pm


Return to Support

Who is online

Users browsing this forum: No registered users and 7 guests