Page 1 of 1

Hide camera name/timestamp/status?

PostPosted: Thu Mar 21, 2013 10:29 am
by scottt732
Is it possible to hide the red/green text in the upper left corner in the android app? I'm using an old cell phone as an always on monitor and when the text changes in my peripheral vision, I confuse it with motion. Ideally I'd like nothing but the video on the screen.

Re: Hide camera name/timestamp/status?

PostPosted: Tue Apr 16, 2013 12:06 pm
by N4Spd
next few releases will add record schedule, motion detection, sound on motion detect and notifications on motion detect so hang on.

Re: Hide camera name/timestamp/status?

PostPosted: Thu May 16, 2013 12:12 pm
by moranche
Hi,
I just tried V4.9 version (free version) on a tablet
it seems that motion detection and connection loss doesn't play any sound, even declared (and played sample) on parameters section
is there any thing else to adjust?
is it device dependent?

Re: Hide camera name/timestamp/status?

PostPosted: Sun May 19, 2013 11:03 pm
by N4Spd
1. change sounds in App Settings.

2. see Edit Camera -> More Options for motion detection options

3. motion detection will take ~1-2 minutes to learn before working

moranche wrote:Hi,
I just tried V4.9 version (free version) on a tablet
it seems that motion detection and connection loss doesn't play any sound, even declared (and played sample) on parameters section
is there any thing else to adjust?
is it device dependent?

Re: Hide camera name/timestamp/status?

PostPosted: Tue May 21, 2013 11:22 am
by moranche
hi,
I did'nt notice that i must set options for each cam
I did it and it seems to work
except than, as the motion on this cam is acting only during 30s and the application needs 1-2 minutes to detect an alarm, this one is often missed
if several detections occur successively within 2mns, a sound is effectively played
if only one detection, no sound is played
I think it's a problem with this cam (Vstarcam h6837Wi), I don't know how operate other cams
rgds

Re: Hide camera name/timestamp/status?

PostPosted: Mon Jun 17, 2013 11:31 am
by N4Spd
1. motion detection takes 1-2 minutes to learn before it starts working

2. motion will turn status orange but repeated motion is required to trigger sound notification (if enabled). this repeated requirement will also be required for future mobile notifications in order to minimize false positives

3. constant motion areas will be ignored over time (part of learning). same goes the other way (will re-learn calm areas over time)

Re: Hide camera name/timestamp/status?

PostPosted: Mon Jun 04, 2018 10:27 am
by Zusan
Iam sorry, to reopen this extremely old thread,but I have the exact same question as the thread opener and the questions has not been answered as far as I could find out.